here is what I did.
I am running Ubuntu 15.10, and I installed Aircrack on it.
When I did
Code: Select all
airmon-ng check kill
I restarted it using
Code: Select all
/etc/init.d/network-manager restart
The Wi-fi icon still shows that I am connected but I cannot connect until I typr in my Wi-fi password again. This happens to me all the time.
What is the solution to this??
Also as you understand by now that I was trying to monitor the networks around me for very obvious reasons, when I try to put the following code
Code: Select all
airmon-ng start <Interface Name>
Code: Select all
airmon-ng start wlp2s0
Found 5 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!
PID Name
6981 avahi-daemon
6982 avahi-daemon
7091 NetworkManager
7112 wpa_supplicant
9322 dhclient
PHY Interface Driver Chipset
phy0 wlp2s0 ath9k Qualcomm Atheros QCA9565 / AR9565 Wireless Network Adapter (rev 01)
Newly created monitor mode interface wlp2s0mon is *NOT* in monitor mode.
Removing non-monitor wlp2s0mon interface...
WARNING: unable to start monitor mode, please run "airmon-ng check kill"
Code: Select all
Qualcomm Atheros QCA9565 / AR9565 Wireless Network Adapter
I even went ahead and edited the
Code: Select all
NetworkManager.conf
Code: Select all
[keyfile]
unmanaged-devices=interface-name:wlan0mon;interface-name:wlan1mon;interface-name:wlan2mon;interface-name:wlan3mon;interface-name:wlan4mon;interface-name:wlan5mon;interface-name:wlan6mon;interface-name:wlan7mon;interface-name:wlan8mon;interface-name:wlan9mon;interface-name:wlan10mon;interface-name:wlan11mon;interface-name:wlan12mon # 30/08/2015: avoid conflicts with airmon-ng
changed the names, removed them and added a couple of new ones and also added the name which my Adapter uses
Code: Select all
wlp2s0
and still no change.
Hope this illustrates my problem properly... Please let me know if I should post more details.
Ooh one more thing. I was trying to do the same with Kali on live but the thing won't move... I got the Interface name as wlan0 in there but when ever I did
Code: Select all
airmon-ng start wlan0
Code: Select all
mon
Code: Select all
airmon-ng start wlan0
Code: Select all
mon
Code: Select all
wlp2s0monmonmon